Инструкция по разоборке ноутбука Acer Aspire 5610z [ENG]

In this guide I show how to disassemble an Acer Aspire 5610z laptop (also says Model BL50 on the bottom).

Most likely this guide will work for some other Acer Aspire 56XX models. If this guide works for you, please mention the model number in comments after this post.

Before you start, make sure the computer is turned off and battery removed.

Если на вашем ноутбуке «слабая» батарея (аккумулятор), держит ноутбук в работе всего несколько минут или не держит совсем, то она требует замены. Вы можете самостоятельно приобрести аккумулятор в интернет магазине и установить его в ноутбук.

ШАГ 1.

Remove eight screws securing the memory and hard drive covers on the bottom. Remove both covers.

There is one more cover on the bottom and there is nothing under it. I called it Blank cover and removed it too.

ШАГ 2.

When all covers removed, you can access both memory (RAM) modules, hard drive assembly, cooling fan, wireless card, heat sink and CPU.

In the following steps I’ll remove some of these parts.

ШАГ 3.

In Acer Aspire 5610z both memory modules can be accessed from the door on the bottom.

In order to remove the memory module, carefully spread latches on both sides of the memory slot. After the memory module pops up at a 30 degree angle, carefully pull it from the slot by the edges.

Use same steps to remove the second module.

This laptop can take up to 2GB RAM total. Each slot can take up to 1GB RAM module. Use DDR2-533 SODIMM memory modules.

ШАГ 4.

Slide the hard drive assembly to the right and disconnect it from the motherboard.

Now you can remove the HDD assembly.

ШАГ 5.

If you are replacing the hard drive, you’ll have to transfer the caddy to the new one.

Simply remove two screws from each side of the caddy and separate it from the drive.

As you see, this is a regular 2.5? SATA HDD.

Any 2.5? SATA HDD should work fine in Acer Aspire 5610z.

ШАГ 6.

Remove one screw securing the DVD drive.

Slide the DVD drive to the left and remove it from the case.

ШАГ 7.

Remove two screws securing the cooling fan.

Disconnect the cooling fan cable from the motherboard.

ШАГ 8.

Now you can remove the fan.

If the cooling fan and heat sink clogged with dust, blow it off with compressed air.

Если вентилятор ноутбука шумит, гудит или совсем не вращается, можно провести его профилактику (почистить и смазать), но данная процедура не гарантирует долгой работы кулера в будущем. Лучшим вариантом будет его замена на новый, приобрести вентилятор (кулер) к Acer Aspire 5610 и установить можно самостоятельно.

ШАГ 9.

Carefully disconnect both antenna cables from the wireless card.

ШАГ 10.

Remove the wireless card same way you removed memory modules.

In the following seven steps I explain how to remove the laptop keyboard.

In order to remove the keyboard it’s not necessary to go through steps 1-10.

ШАГ 11.

Lift up the right side of the power button board/hinge cover. I’m using a guitar pick.

Continue removing the cover with your fingers.

ШАГ 12.

The cover has been removed.

ШАГ 13.

Remove two screws securing the keyboard.

ШАГ 14.

Lift up the top side of the keyboard and carefully separate it from the top cover.

Be careful, it’s still connected to the motherboard.

ШАГ 15.

Now you can access the cable connector and unlock it.

ШАГ 16.

In order to unlock the connector you’ll have to move the brown clip about 2-3 millimeters towards the laptop display.

The brown clip MUST stay attached to the white connector base.

On the following picture the connect is shown in the unlocked position. Do not move the brown clip any further.

ШАГ 17.

When the connector is unlocked, you can release the cable and remove the keyboard.

Если на клавиатуре ноутбука не работают клавиши, то с вероятносью 99% клавиатуру надо будет менять на новую, чистка клавиатуры как правило не помогает. Приобрести клавиатуру к ноутбуку и установить можно самостоятельно. Например, клавиатура к Acer Aspire 5610 с доставкой обойдётся совсем недорого. Обязательно заказывайте клавиатуру для своего языка.

In order to remove the display panel you’ll have to disconnect the video cable and remove four screws securing the display hinges.

Шлейф LCD матрицы часто перегибается и нередко требует замены. Основнями признаками поломки шлейфа является «черный экран», полосы по экрану или другие дефекты изображения, которые обычно появляются в моменты открытия/закрытия ноутбука. Поломка кабеля обычно происходит в районе петель корпуса, тоненькие проводки просто переламываются и восстановить их зачастую невозможно. Новый видео-кабель (шлейф) LCD матрицы можно самостоятельно приобрести и земенить не прибегая к услугам сервисного центра.

In one of the previous guides I explained how to remove the screen.

Всё! Ноутбук разобран. Сборка происходит в обратном порядке, если у вас возникнут сложности вы всегда можете обратиться к специалистам.

Источник: www.insidemylaptop.com

Карта разрушений и жертв российской агрессии в городе Мариуполь, на карте отмечены более 2000 пострадавших домов. На карте отмечены не только фото домов, но свидетельства их жителей, а так же место боевых...

Из-за военных событий 2014 года в Донецке тренер по плаванию Алексей Снежко и его жена вынужденно переехали в Киев. А теперь, в 2022-м, 33-летний Алексей потерял обоих родителей в Мариуполе. Как пережить...

«20 днів у Маріуполі». Ще один фільм про блокадний Маріуполь з подіями березня 2022 року. Повномасштабне російське вторгнення в Україну журналісти зустріли у Маріуполі разом із жителями міста...

Компьютерный мирSector

Вся информация на страницах сайта предназначена только для личного не коммерческого использования, учёбы, повышения квалификации и не включает призывы к каким либо действиям.

Частичное или полное использование материалов сайта разрешается только при условии добавления ссылки на непосредственный адрес материала на нашем сайте.